|FA171076||Would digital inputs of LXM32 servo range drives take effect when SoMoveLite control panel access is enabled.|
When SoMoveLite control panel access is enabled, it is exclusive control and will be given top priority. So, effect
of activating digital inputs physically...
|FA171072||What is the difference between pre-cabled connectors (1) XZ CP1141L2 and (2) XZ CP1169L2 when both are 4 pins, female, straight and M12 connectors.|
Difference between (1) XZ CP1141L2 and (2) XZ CP1169L2 is as below.
==> XZCP1141L2 is a straight, 4 pins M12 Female connector with PUR cable of...
|FA170718||In a linear load application, is IT earthing acceptable to use AC type C60 Vigi module.|
For IT earthing system must use ASi or ASiE devices to avoid nuisance tripping of C60 Vigi modules.
The main reason is due to Neutral line is not...
|FA170716||Is it necessary to connect the Acti9 range of contactor (iACT24) to the 230VAC power supply.|
The 24VDC is just used to send the command, from Acti 9 Smartlink or a PLC. To be able to energize the coil of the
associated contactor, the iACT24...
|FA170714||What is maximum length of the cable between MCB and Acti9 Smartlink.|
The cable length between an input of the Acti9 Smartlink and any device connected is limited to 20 meters.
|FA170712||What's the burden of BCPM power consumption.|
The BCPM is fused at 500mA so, that will be the absolute maximum it could draw, however we expect normal draw to be less than 100mA.
So if the...
|FA170616||Is it possible to operate or configure ATV303 drive with remote HMI |
Yes, it is possible to operate and / or to configure ATV303 drive by means of remote HMI Part reference VW3A1006.
|FA170610||When Lexium 32 range of servo drive goes into the “QUICK STOP”.|
Lexium 32 range of servo drive goes into the QUICK STOP under two conditions
If servo drive meet with an error of class 1 or class 2.
|FA170609||In Lexium range drive the permissible range of motor shaft movement if absolute position is to be retained while servo drive is powered off.|
Permissible range of motor shaft movement is +/ - 0.25 revolution from the position at which motor shaft position was
at the moment servo drive was...
|FA170608||In Altivar range of drives ,display of current (A) is blinking on 7 –segment LED display. What does this mean.|
Blinking of Current (A) displayed on 7-segment LED display indicates that drive has reached to the current limitation.
This occurs when current drawn...